Nippon QA-436 low-odor interior topcoat application unique formula designed to make the coating to minimize volatile organic matter content, is ideal for interior decoration health products. Nippon low odor paint does not add flavor, low and moderate odor tank within 24-48 hours after the completion of construction, that there was no odor. Product Features: 1. Low odor, low and moderate odor tank, after 24-48 hours after construction there was no odor;. 2. The very low content of volatile organic compounds, and to maintain the same standard of advanced countries and <30 g / L; 3. Easy construction. Easy to clean; 4. Excellent improve adhesion and scrub resistance; 5. can inhibit the growth of mold. Applications: for families, children's bedroom, hospitals, hotels, restaurants, schools, painting, especially for applications that require recoating but there are still people living environment of the painting. Surface treatment: Before painting, interior cement walls and ceiling surfaces must be firm, smooth, dry, clean and free of dust, it should be noted:? 1. high humidity humidity adhesion of the coating and the wall fell, causing the coating from bubbles and blur, it requires less than 10% humidity. 2. Alkaline? Inner wall due to the presence of alkaline substances or salt, in the drying process will vary moisture seeping through the wall surface, causing blistering and blur film. These materials should be made completely from seeping inside the wall, until after a pH of less than 10 before painting. Can take the following methods, depending on the wall situation: ● The new wall (not the over-paint) 1. Ensure that the wall has sufficient curing time (4-8 weeks), and fully dry, remove mortar residue and any loose surface material . 2 small holes and cracks such as paint can not fill level, in line with national standards required repair smooth interior wall putty to get smooth and soft surface. After using the repair materials, wall should be thoroughly dried. 3. small grease dirt and dust using a mild detergent or solvent cleaning, then rinse and dry; or scrub with a damp cloth to completely remove all stains. ● old wall (not the over-paint) 1. First check the wall condition, treatment by the method mentioned earlier, depending on surface defects. 2. Clear the wall of dust accumulation. 3. Wall breeding mold or mildew moss was treated by the state legislature, and then washed with water and dried. ● old wall (painted over paint) 1. original coating intact attached to the wall surface to remove dirt, clean up directly after brushing clean. 2. wall contraction and cracks should be used putty repair flat. 3. The old paint cracked, blistering and peeling when it should be completely removed after the repair sanding, clean surface. Color: white and light-colored, but also meet the specific requirements, but with the addition of colorants, odors and volatile organic compounds content will also increase. Note: Confirm the substrate before coating reaches painting requirements; should be between 5 ~ 35 ℃ painting, painting requires air humidity should be less than 85%; select the appropriate construction methods and appropriate construction tools, as recommended Construction technology for the construction work; Control Coating interval, after reaching recoat time before the next coat of paint brushing. Recoat time is too short can cause the following paint drying slowly, wrinkling and other issues; washing tools: Tools cleaned immediately after use with water and allow to dry. Drying time: dry: 30 minutes / 25 ℃ Recoat time: more than 2 hours / 25 ℃. (Drying time will vary with ambient temperature and humidity changes) Storage: Store at 0 ~ 35 ℃, cool, clean, dry place, the rest of the paint should be good closures, impurities can cause paint deterioration. If you do not open the product and properly stored, and storage is valid for 2 years.